100% Pass Your HPE6-A66 Exam Dumps at First Attempt with Test4Sure
Penetration testers simulate HPE6-A66 exam PDF
NEW QUESTION 27
Which IRIS option will automatically create a project with a blank preconfigured Site-1 ?
- A. New Express Mode
- B. New Project
- C. New Campus
- D. New Site
Answer: C
NEW QUESTION 28
A network architect is doing a site survey for a new wireless design One concern the company has with the old wireless network is coverage. In some cases, APs would lose power and some employees in the network would lose wireless connectivity. The new design needs to prevent this issue from occurring. During the site survey, what are best practices to be followed in regards to the dBm signal level and the power of the AP to ensure adequate wireless coverage and minimal overlap of AP signals for the new design?
- A. AP power at 50% and a measurement of -65 dBM on the measuring device
- B. AP power at 75% and a measurement of -90 dBM on the measuring device
- C. AP power at 75% and a measurement of -80 dBM on the measuring device
- D. AP power at 100% and a measurement of -65 dBM on the measuring device
Answer: D
NEW QUESTION 29
A company has hired a network architect to replace an existing legacy wireless and wired network The building is one-story and contains four wiring closets Based on the information the network architect gathered from the company, one 48-port POE+ switch and three 48-port non-POE+ switches will be placed in each wiring closet. One stacking domain should be created for each wiring closet that supports 40 Gbps uplinks.
Which stacking solution should the architect implement for the floor that meets the requirements and is the most cost-effective'?
- A. VSX
- B. Distributed trunking
- C. Backplane stacking
- D. VSF
Answer: A
NEW QUESTION 30
A high-end theater venue will be implementing an Aruba wireless solution using ceiling- and wall-mounted APs. The venue wants to ensure the the APs blend into the ceiling and wall environments. What solution should the customer use to ensure that wireless coverage is not hampered?
- A. Paint the APs to match the ceilings or walls
- B. Place a strip of tape over the LEDs
- C. Order Aruba AP covers for the APs
- D. Place the APs above the ceiling and behind the walls
Answer: D
NEW QUESTION 31
A customer placed an order for an ArubaOS 5406R switch and plans to rack mount it in a wiring closet. The dimensions of the switch are 17.5 inches wide (44.45 cm), 6.9 inches high (17.5 cm), and 17.75 inches deep (45.1 cm). How many rack units should a customer plan for this switch?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 32
NewRocket requires a wireless capacity design 30 Aruba 510 APs will be connected to each wiring closet using SmartRate connections. Wireless coverage needs to be provided even if a POE+ switch loses power Because of security concerns, wired video cameras were recently installed throughout the facility. There are 12 of these per floor. 6 per wiring closet. The cameras are 802.11n WiFi capable and have power injectors from which to draw power.
Based on the POE+ needs of the mentioned devices, which solution would meet the POE+ requirements while still providing a redundant and cost-effective Wi-Fi solution for the devices that require POE+ for Building 1, Floor 2?
- A. One 3810M 40G 8 HPE Smart Rate switch
- B. Two 2930M 24-port POE+ switches
- C. Two 2930F 24-port POE+ switches
- D. One 2930M 48-port POE+ switch
Answer: D
NEW QUESTION 33
A customer is designing a new wired network. The customer requires 50 Gbps uplinks, VSF logical switching, and smart rate port support Which of the following switches would meet these requirements?
- A. 5400R series
- B. 3810M series
- C. 8300 series
- D. 6300 series
Answer: B
NEW QUESTION 34
A company has two buildings on a campus that are approximately 700 feet (214 meters) apart with a clear line of site. No fiber exists between the buildings; however, there is a need for connecting the networks in the buildings together. The connection between the two buildings will need to support peak rates over 1 Gbps.
Which solution should the company choose that will meet their requirements as well as being cost-effective?
- A. Two outdoor AP 510s
- B. Two outdoor AP 367s
- C. Two outdoor AP 387s
- D. Multi-mode fiber between campus switches
Answer: B
NEW QUESTION 35
A network architect imports a floorplan defined in a PNG file format What is the function of the measurement tool in Aruba's VisualRF?
- A. Define the appropriate dimensions of each room in a Floorplan View
- B. Define the appropriate dimensions of a Floorplan and Building View
- C. Define the appropriate dimensions of a Floorplan View
- D. Define the appropriate dimensions of each object in a Floorplan View
Answer: D
NEW QUESTION 36
Refer to the exhibit.
When planning the use of Cat7 cabling for a SmartRate connection between an ArubaOS AP and an ArubaOS switch, which sections should be considered when calculating distance?
- A. A + B
- B. A + C
- C. A + B + C
- D. A + B + C + D
Answer: D
NEW QUESTION 37
A company has chosen an Aruba mobility controller solution for the redesign of their wireless network The design will have two 7205 controllers in a cluster for campus employees and a single VMC-50 virtual controller for remote access via a DMZ. A Mobility Master (MM) is used for centralized license and controller management. All controllers will minimally run ArubaOS 8 4 or later Currently the company has 1.000 employees. There are 30 branch offices that will use RAPs to connect to the DMZ controller. A peak of 100 users concurrently using the VIA client will also connect to the DMZ controller.
How many Aruba LIC-VIA licenses does the company need to purchase for this solution?
- A. 0
- B. 1
- C. 1,030
- D. 2
Answer: C
NEW QUESTION 38
A network architect will be using VisualRF to determine the appropriate wireless coverage for a new wireless design. Seamless, uninterrupted roaming is necessary for this design, since voice will need to be supported. Given these requirements, which information should be used in VisualRF to plan a cost effective solution that meets these requirements?
- A. Minimum -65db, 1 AP per 2,500 square feet, high density design
- B. Minimum -80db, 1 AP per 1,000 square feet, very high-density design
- C. Minimum -70db, 1 AP per 2,500 square feet, capacity design
- D. Minimum -70db. 1 AP per 5,000 square feet, high density design
Answer: A
NEW QUESTION 39
When determining a customer's agenda and clarifying their expectations for a new HPE/Aruba deployment, which two questions should be asked during the stakeholder checklist? (Select two.)
- A. What is the networking experience of onsite personnel?
- B. What business problems are you trying to solve?
- C. Which help desk system is deployed?
- D. What is your anticipated growth of the environment?
- E. is a request for proposal or actual bill of materials (BOM) required?
Answer: B,E
NEW QUESTION 40
A wiring closet with a POE+ switch is 250 feet (76 meters) away from an AP on a building floor. The AP's smart-rate port is connected to a smart-rate port on the switch, which is capable of 10 Gbps. The cable type is Cat5e STP. What is the maximum speed that the customer can expect from the connected AP?
- A. 5 Gbps
- B. 1 Gbps
- C. 10 Gbps
- D. 2.5 Gbps
Answer: D
NEW QUESTION 41
A customer currently has sets of three Aruba 5406R switches deployed for an access layer in multiple wiring closets in a building They are clustered in a VSF domain The customer wants to set up Multiple Active Detection (MAD) for the OOBM port, as well as use this port for remote management access. To simplify the connectivity, the customer wants to connect these three switches' OOBM ports to a separate switch in the wiring closet for the OOBM connectivity.
Which would be the most cost-effective solution that would meet the customer's requirements?
- A. 2930M
- B. 0
- C. 2930F
- D. 5406R
Answer: B
NEW QUESTION 42
A network architect is designing a new wireless solution for a company The company needs seamless roaming and client and AP active load balancing. The company also requires an Aruba Mobility Master (MM) to manage the wireless infrastructure. Which Aruba feature does the architect need to include in the design?
- A. Client Match
- B. IAP VC
- C. Clustering
- D. AirMatch
Answer: C
NEW QUESTION 43
A customer requires Aruba switches that support Smart Rate ports to connect to Aruba APs Which switching product should the customer purchase that will provide 24 Smart Rate ports per access layer switch'?
- A. Aruba 2930F
- B. Aruba 2540
- C. Aruba 2930M
- D. OfficeConnect 1950
Answer: C
NEW QUESTION 44
A network architect has created two sites in IRIS and defined network devices for each site. From which window would a network architect connect the two sites together?
- A. Site-1
- B. Topology
- C. Start Page
- D. Catalog
Answer: A
NEW QUESTION 45
A network architect is creating a new wireless solution for a customer. Wireless coverage is required throughout all four floors of two buildings on the same campus. Dynamic RF capabilities, including AirMatch, are required. Seamless roaming is required within and between the two buildings. Each floor will have approximately 20 APs and 6 external APs are required for connectivity between the two buildings.
- A. A standalone 7008 controller per floor
- B. Two 7205 mobility controllers in a cluster
- C. Given this information, which Aruba solution would be the most cost-effective while still meeting the customer's requirements? O An IAP cluster per floor
- D. Two 7030 mobility controllers in a cluster
Answer: C
NEW QUESTION 46
A network architect is designing a wireless solution for a company that is leasing one floor in a multi-floor building in a downtown area. The customer is concerned about ensuring complete Wi-Fi coverage and pin-pointing RF hazards. What type of survey should the network architect perform?
- A. Active
- B. Virtual
- C. Spectrum clearing
- D. Passive
Answer: A
NEW QUESTION 47
A network architect has developed a design for a new Aruba Wi-Fi network that will include a hardware Mobility Master (MM) running the ArubaOS 8 4 operating system that will manage:
* Two clustered 7205 controllers with 300 campus APs
* Two clustered VMC-50 controllers with 75 remote APs
The architect plans on creating user roles, firewall policies, and wireless IPS policies on the controllers as well as implementing AirMatch. What would meet the license requirements for this scenario?
- A. LIC-MM-VA-500. LIC-MC-VA-50 (X2), LIC-AP <x375). PEF (x375). RFP (x375)
- B. LIC-MC-VA-50 (X2), LIC-AP (375), PEF (X375), RFP (X375)
- C. LIC-MC-VA-50 (x1), LIC-AP (300), PEF (X300). RFP (x300)
- D. LIC-MM-VA-50, LIC-MC-VA-50 (X1), LIC-AP (X300), PEF <x300). RFP (x300)
Answer: D
NEW QUESTION 48
A network architect has developed a design for a new Aruba Wi-Fi network that will include a virtual Mobility Master (MM) running the ArubaOS 8.4 operating system that will manage:
* Two clustered 7210 controllers with 600 campus APs
* Two clustered VMC-50 controllers with 75 remote APs
* Wireless IPS
The architect plans on creating user roles and firewall policies on the controllers as well as implementing AirMatch. What would meet the license requirements for this scenario?
- A. LIC-MM-VA-50 (X1), LIC-MC-VA-50 (x2). LIC-AP (X675), PEF (x675), RFP (X675)
- B. LIC-MM-VA-1000 (X1), LIC-MC-VA-50 (x1), LIC-AP (x600). PEF (X600), RFP (x600)
- C. LIC-MM-VA-1000 (X1), LIC-MC-VA-50 (x2), LIC-AP (X675). PEF (X675). RFP <x675)
- D. LIC-MM-VA-1000 (X1). LIC-MC-VA-50 (X1), LIC-AP (x675). PEF (X675), RFP (X675)
Answer: D
NEW QUESTION 49
......
All HPE6-A66 Dumps and Training Courses: https://www.test4sure.com/HPE6-A66-pass4sure-vce.html
Help candidates to study and pass the Aruba Certified Design Associate Exam Exams hassle-free: https://drive.google.com/open?id=12ehRmP50x1uyla_kAFl7eEYDqZj3eu4x