Cisco 300-730 Daily Practice Exam New 2023 Updated 148 Questions
Use Valid 300-730 Exam - Actual Exam Question & Answer
Cisco 300-730 exam is a certification exam designed to test the knowledge and skills of IT professionals in implementing secure solutions with virtual private networks (VPNs). 300-730 exam is one of the requirements to obtain the Cisco Certified Specialist - Security Identity Management Implementation certification. Implementing Secure Solutions with Virtual Private Networks certification is intended for professionals who want to specialize in the implementation of secure identity management solutions.
NEW QUESTION # 52
A network engineer must design a clientless VPN solution for a company. VPN users must be able to access several internal web servers. When reachability to those web servers was tested, it was found that one website is not being rewritten correctly by the ASA.
What is a potential solution for this issue while still allowing it to be a clientless VPN setup?
- A. Set up a WebACL to permit the IP address of the web server.
- B. Set up a smart tunnel with the IP address of the web server.
- C. Set up a NAT rule that translates the ASA public address to the web server private address on port 80.
- D. Set up Cisco AnyConnect with a split tunnel that has the IP address of the web server.
Answer: C
NEW QUESTION # 53 
Refer to the exhibit. The IKEv2 site-to-site VPN tunnel between two routers is down. Based on the debug output, which type of mismatch is the problem?
- A. transform set
- B. preshared key
- C. peer identity
- D. ikev2 proposal
Answer: C
Explanation:
Section: Troubleshooting using ASDM and CLI
NEW QUESTION # 54
A second set of traffic selectors is negotiated between two peers using IKEv2. Which IKEv2 packet will contain details of the exchange?
- A. IKEv2 IKE_SA_INIT
- B. IKEv2 IKE_AUTH
- C. IKEv2 CREATE_CHILD_SA
- D. IKEv2 INFORMATIONAL
Answer: D
NEW QUESTION # 55
Which parameter must match on all routers in a DMVPN Phase 3 cloud?
- A. EIGRP split-horizon setting
- B. GRE tunnel key
- C. NHRP network ID
- D. tunnel VRF
Answer: B
NEW QUESTION # 56
Refer to the exhibit.
An IKEv2 site-to-site tunnel between an ASA and a remote peer is not building successfully. What will fix the problem based on the debug output?
- A. Install the correct certificate to validate the peer.
- B. Ensure crypto IPsec policy matches on both VPN devices.
- C. Specify the peer IP address in the tunnel group name.
- D. Correct crypto access list on both VPN devices.
Answer: B
NEW QUESTION # 57
Refer to the exhibit.
Which VPN technology is used in the exhibit?
- A. VTI
- B. DVTI
- C. DMVPN
- D. GRE
Answer: A
NEW QUESTION # 58
Which two features provide headend resiliency for Cisco AnyConnect clients? (Choose two.)
- A. AnyConnect Network Access Manager
- B. AnyConnect Backup Servers
- C. AnyConnect Always On
- D. AnyConnect Auto Reconnect
- E. ASA failover
Answer: B,E
Explanation:
Section: Remote access VPNs
NEW QUESTION # 59
An engineer is configuring clientless SSL VPN. The finance department has a database server that only they should access, but the sales department can currently access it. The finance and the sales departments are configured as separate group-policies. What must be added to the configuration to make sure the users in the sales department cannot access the finance department server?
- A. smart tunnel
- B. tunnel group lock
- C. webtype ACL
- D. port forwarding
Answer: B
NEW QUESTION # 60
Refer to the exhibit.
A network engineer is configuring a remote access SSLVPN and is unable to complete the connection using local credentials. What must be done to remediate this problem?
- A. Enable the client protocol in the Cisco AnyConnect profile.
- B. Configure a AAA server group to authenticate the client.
- C. Change the authentication method to local.
- D. Configure the group policy to force local authentication.
Answer: A
NEW QUESTION # 61
Which requirement is needed to use local authentication for Cisco AnyConnect Secure Mobility Clients that connect to a FlexVPN server?
- A. use of certificates instead of username and password
- B. EAP-AnyConnect
- C. AnyConnect profile
- D. EAP query-identity
Answer: B
Explanation:
https://www.cisco.com/c/en/us/support/docs/security/flexvpn/200555-FlexVPN-AnyConnect-IKEv2-Remote-Access.pdf
NEW QUESTION # 62
Refer to the exhibit.
DMVPN spoke-to-spoke traffic works, but it passes through the hub, and never sends direct spoke-to-spoke traffic. Based on the tunnel interface configuration shown, what must be configured on the hub to solve the issue?
- A. Enable NHRP shortcut.
- B. Enable NHRP redirect.
- C. Enable IP redirects.
- D. Enable split horizon.
Answer: A
NEW QUESTION # 63
Refer to the exhibit.
Which type of mismatch is causing the problem with the IPsec VPN tunnel?
- A. Phase 1 policy
- B. transform set
- C. crypto access list
- D. preshared key
Answer: D
NEW QUESTION # 64
Refer to the exhibit.
Client 1 cannot communicate with client 2. Both clients are using Cisco AnyConnect and have established a successful SSL VPN connection to the hub ASA. Which command on the ASA is missing?
- A. dns-server value 10.1.1.3
- B. same-security-traffic permit inter-interface
- C. same-security-traffic permit intra-interface
- D. dns-server value 10.1.1.2
Answer: C
NEW QUESTION # 65
A user is experiencing delays on audio calls over a Cisco AnyConnect VPN. Which implementation step resolves this issue?
- A. Install the Cisco AnyConnect 2.3 client for the user to download.
- B. Enable DTLS.
- C. Change to 3DES Encryption.
- D. Shorten the encryption key lifetime.
Answer: B
NEW QUESTION # 66
Refer to the exhibit.
Which type of VPN implementation is displayed?
- A. IKEv2 load balancer
- B. IKEv1 cluster
- C. IKEv2 backup gateway
- D. IKEv2 reconnect
Answer: A
NEW QUESTION # 67
When a FlexVPN is configured, which two components must be configured for IKEv2? (Choose two.)
- A. persistence
- B. proposal
- C. preference
- D. method
- E. profile
Answer: B,E
NEW QUESTION # 68
What is a characteristic of GETVPN?
- A. All peers have one IPsec SPI for inbound and outbound communication.
- B. The remote peer for the IPsec session is configured as part of the crypto map.
- C. An ACL that defines interesting traffic must be configured and applied to the crypto map.
- D. Quick mode is used to create an IPsec SA.
Answer: D
NEW QUESTION # 69
Which requirement is needed to use local authentication for Cisco AnyConnect Secure Mobility Clients that connect to a FlexVPN server?
- A. use of certificates instead of username and password
- B. EAP-AnyConnect
- C. AnyConnect profile
- D. EAP query-identity
Answer: C
Explanation:
Section: Remote access VPNs
Explanation
Explanation/Reference: https://www.cisco.com/c/en/us/support/docs/security/flexvpn/200555-FlexVPN-AnyConnect-IKEv2- Remote-Access.html
NEW QUESTION # 70
A network engineer must design a clientless VPN solution for a company. VPN users must be able to access several internal web servers. When reachability to those web servers was tested, it was found that one website is not being rewritten correctly by the ASA.
What is a potential solution for this issue while still allowing it to be a clientless VPN setup?
- A. Set up a WebACL to permit the IP address of the web server.
- B. Set up Cisco AnyConnect with a split tunnel that has the IP address of the web server.
- C. Set up a smart tunnel with the IP address of the web server.
- D. Set up a NAT rule that translates the ASA public address to the web server private address on port 80.
Answer: C
NEW QUESTION # 71
......
Test Engine to Practice 300-730 Test Questions: https://www.test4sure.com/300-730-pass4sure-vce.html
300-730 Real Exam Questions Test Engine Dumps Training With 148 Questions: https://drive.google.com/open?id=1Y9Ni5XqyHLayABj54RcTi8wDrcA4kP9K