[Oct-2021] Valid Way To Pass Cisco Exam Dumps with 300-415 Exam Study Guide
All 300-415 Dumps and Implementing Cisco SD-WAN Solutions Training Courses Help candidates to study and pass the Exams hassle-free!
NEW QUESTION 76
When redistribution is configured between OMP and BGP at two Data Center sites thathave Direct Connection interlink, which step avoids learning the same routes on WAN Edge routers of the DCs from LAN?
- A. Define different VRFs on both DCs
- B. Set down-bit on Edge routers on DC1
- C. Set OMP admindistance lower than BGP admin distance
- D. Set same overlay AS on both DC WAN Edge routers
Answer: C
NEW QUESTION 77
An engineer is troubleshooting a vEdge router and identifies a "DCONFAIL - DTLS connection failure" message. What is the problem?
- A. organization mismatch
- B. connectivity issue
- C. memory issue
- D. certificate mismatch
Answer: B
Explanation:
Section: Controller Deployment
Explanation/Reference: https://community.cisco.com/t5/networking-documents/sd-wan-routers-troubleshoot-control- connections/ta-p/3813237#toc-hId-340740870
NEW QUESTION 78
Which protocol is used to measure loss latency. Jitter, and liveliness of the tunnel between WAN Edge router peers?
- A. BFD
- B. NetFlow
- C. OMP
- D. IP SLA
Answer: A
Explanation:
Reference:
https://www.ciscolive.com/c/dam/r/ciscolive/emea/docs/2019/pdf/TECCRS-2014.pdf
NEW QUESTION 79
Refer to the exhibit.
A network administrator is configuring OMP in vManage to advertise all the paths for the same prefix from a site that has two WAN Edge devices Each WAN Edge device is connected to three ISPs and two private MPLS transports. What is the minimum value for 'Number of Paths advertised per Prefix" that should be configured?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 80
Drag and drop the steps from the left into the order on the right to upload software on vManage repository that is accessible from maintenance > Software Repository.
Answer:
Explanation:
NEW QUESTION 81
Drag and drop the attributes from the left that make each transport location unique onto the right. Not all options are used.
Answer:
Explanation:
NEW QUESTION 82
A network administrator is creating an OMP feature template from the vManage GUI to be applied to WAN edge routers. Which configuration attribute will avoid the redistribution of the routes back into the OMP from the LAN side?
- A. configure "ECMP limit"
- B. configure "Send Backup Paths"
- C. configure "Number of Paths Advertised per Prefix"
- D. configure "Overlay AS Number"
Answer: D
Explanation:
NEW QUESTION 83
Two sites have one WAN Edge each Each WAN Edge has two public TLOCs with no restrict configured.
There is full reachability between the TLOCs. How many data tunnels are formed on each Edge router?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION 84
Refer to the exhibit.
An engineer is troubleshooting a control connection Issue. What does "connect" mean in this how control connections output?
- A. Control connection is down
- B. Control connection is up
- C. Control connection is connected
- D. Control connection attempt is in progress
Answer: D
NEW QUESTION 85
Which pathway under Monitor > Network > Select Device is used to verify service insertion configuration?
- A. ACL Logs
- B. Real Time
- C. System Status
- D. Events
Answer: C
NEW QUESTION 86
Which component of the Cisco SD-WAN architecture oversees the control plane of overlay network to establish, adjust, and maintain the connections between the WAN Edge devices that form the Cisco SD-WAN fabric?
- A. vManage
- B. vSmart
- C. vBond
- D. APIC-EM
Answer: B
NEW QUESTION 87
Which two products are used to deploy Cisco WAN Edge Router virtual platforms? (Choose two.)
- A. Sun Enterprise M4000 Server running Sun Solans
- B. HP ProLiant DL360 Generatton10 running HP-UX
- C. Cisco ENCS 5000 Series
- D. Cisco UCS
- E. Sun SPARC Node running AIX
Answer: C,D
Explanation:
Explanation
https://www.cisco.com/c/en/us/products/collateral/routers/5400-enterprise-network-compute-system/datasheet-c7
NEW QUESTION 88
A transport side of the network is down on the master device. What must be configured to get the fastest failover to standby?
- A. lower timer interval
- B. OMP tracking
- C. prefix-list tracking
- D. higher group ID number
Answer: A
Explanation:
https://sdwan-docs.cisco.com/Product_Documentation/Software_Features/SDWAN_Release_16.3/02System_and_Interfaces/06Configuring_Network_Interfaces/Configuring_VRRP
NEW QUESTION 89
Which Cisco SD-WAN WAN Edgeplatform supports LTE and Wi-Fi?
- A. vEdge2000
- B. CSR 1000v
- C. ASR1001
- D. ISR 1101
Answer: B
NEW QUESTION 90
A network administrator is tasked to make sure that an OMP peer session is closed after missing three consecutive keepalive messages in 3 minutes. Additionally, route updates must be sent every minute. If a WAN Edge router becomes unavailable, the peer must use last known information to forward packets for 12 hours. Which set of configuration commands accomplishes this task?
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: A
Explanation:
https://sdwan-docs.cisco.com/Product_Documentation/vManage_Help/Release_17.2/Configuration/Templates/OMP
NEW QUESTION 91
When redistribution is configured between OMP and BGP at two Data Center sites that have Direct Connection interlink, which step avoids learning the same routes on WAN Edge routers of the DCs from LAN?
- A. Set same overlay AS on both DC WAN Edge routers
- B. Define different VRFs on both DCs
- C. Set OMP admin distance lower than BGP admin distance
- D. Set down-bit on Edge routers on DC1
Answer: A
Explanation:
NEW QUESTION 92
In a Cisco SD-WAN network, which component is responsible for distributing route and policy information via the OMP?
- A. vManage
- B. vSmart Controler
- C. vBond Orchestrator
- D. WAN Edge Router
Answer: B
Explanation:
NEW QUESTION 93
Which component is responsible for routing protocols such as BGP and OSPF in a Cisco SD-WAN solution?
- A. vManage
- B. vBond Orchestrator
- C. WAN Edge Router
- D. vSmart Controller
Answer: C
Explanation:
NEW QUESTION 94
Which OSPF command makes the WAN Edge router a less preferred exit from a site with a dual WAN Edge design?
A)
B)
C)
D)
- A. Option A
- B. Option D
- C. Option B
- D. Option C
Answer: B
NEW QUESTION 95
An engineer is configuring a WAN Edge router for DIA based on matching QoS parameters. Which two actions accomplish this task? (Choose two.)
- A. Apply a QoS map policy.
- B. Configure NAT on the transport interface.
- C. Apply a data policy on WAN interface.
- D. Configure a centralized data policy.
- E. Configure a control policy.
Answer: B,D
Explanation:
https://www.cisco.com/c/dam/en/us/td/docs/solutions/CVD/SDWAN/sdwan-dia-deploy-2020aug.pdf
NEW QUESTION 96
What is a description of vManage NMS?
- A. It is accessible only from VPN 512 (the management VPN).
- B. A cluster consists of a minimum of two vManage NMSs.
- C. It is a software process on a dedicated WAN Edge router in the network.
- D. A cluster requires device templates to be created on an attached to the same server.
Answer: A
Explanation:
Section: Management and Operations
Explanation/Reference:
NEW QUESTION 97
......
Real Exam Questions & Answers - Cisco 300-415 Dump is Ready: https://drive.google.com/open?id=1fq2Xc_blkWtzCnpRU5BBh3q225lAF8mV
Get Latest [Oct-2021] Conduct effective penetration tests using Test4Sure 300-415